Documentation for NS-24 ELAN Driver v1

Setup
	• Disable authentication via console port or telnet
		Login to switch (Jtechdigital, JTD@793v2)
		config
		aaa authentication login default none
	• Access the NS-24 Web UI (default IP: 192.168.168.254)
	• Configure network switch with network settings, port names and port settings as required. Ensure that the controller is on the same
	  network segment as the NS-24 to enable control.
	• Add driver to project in the Configurator as a Media - Audio Zone Controller via local folder browse.
	• Set IP address of the NS-24 on the driver properties page in the Configurator.
	• The driver should initialize with data from the NS-24 within 10 seconds.
	• Add sources to the Sources listed under the NS-24 source list based on what port the TX is connected to
		• e.g. By default, Port 1 is Source 1, Port 10 is Input/Source 10; Port 12 is Output/Zone 1, Port 22 is Output/Zone 10.
		• Depending on your needs, you may decide to reallocate the ports as a different configuration of Input/Source and Output/Zone.
		  To maintain flexibility, all ports are available as Input or Output in the driver. For functional results, you'll need to be
		  consistent in physical port and virtual mapping.
	• If the configuration on the NS-24 is changed, to update the ELAN driver you can use the Update button and reload the driver file.

Operation
	• Switch sources from outputs via media page zones.
	• Switch sources on matrix via zone configuration page.
	• Switch modes from the zone configuration page.
	• Alternatively, custom pages can be created with free placement of buttons for design needs. 
	  In custom pages, you can control the driver via Universal Commands and Event Maps.